1. Turn the appliance on.
2. Select 1 of the available programmes.
3. Touch and hold down the Nivel de Sec.
and Anti-arrugas/Rugas buttons at the
same time.
One of the symbols appears on the display:
- Maximum dryness
- Extra dryness
- Standard dryness
4. Touch the Inicio/Pausa button repeatedly
until you reach the desired target final
moisture .
Dryness level Display symbol
maximum dry‐
ness
more dry laun‐
dry
standard dry
laundry
5. To memorise the setting touch and hold
down the Nivel de Sec. and Anti-
arrugas/Rugas buttons at the same time
for approximately 2 seconds.
7.2 Anti-arrugas/Rugas
Extends up to 120 minutes the anti-crease
phase (30 minutes) at the end of the drying
cycle. After drying phase drum rotates from
time to time to prevent creases. Laundry can
be removed during the anti-crease phase.
7.3 Alarm.
The acoustic signal sounds at the following:
• cycle end
• start and end of crease guard phase
The acoustic signal is by default always on.
You can use this option to activate or
deactivate the sound.
7.4 Tiempo/Tempo sec.
For: Algod., Ropa de Cama/Lençóis XL,
Sintéticos and MixDry programs. Lets the
user to set drying time from minimum 10 min
to maximum of 2 hours (in 10 min steps).
When this option is maximum, load indicator
disappears.
The cycle lasts as long as set drying time
regardless of the size of a load and its
dryness.
TIME DRYING RECOMMENDATION
up 10 min action of cool air only (no heater).
10 - 40
min
additional drying to improve dryness af‐
ter previous drying cycle.
> 40 min
full drying of the small laundry loads up
to 4 kg, well spun (>1200 rpm).
7.5 Tiempo/Tempo sec. on Lana/Lãs
program
Option applicable to Lana/Lãs program to
adjust final dryness level to more dry or less
dry.
7.6 Inicio Diferido
Lets to delay the start of a drying
program from minimum of 30 minutes to
maximum of 20 hours.
8. SETTINGS
8.1 Deactivating the water container
indicator
The water container indicator is activated by
default. It illuminates at the end of the drying
cycle or during the cycle if the water reservoir
is full. If the draining kit is installed the water
container is drained automatically and the
indicator can be deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Select 1 of the available programmes.
42 ENGLISH
To Next Page
Loading...
