Problem Possible cause Remedy
Unsatisfactory drying
result.
Incorrect program selection.
Select a suitable program.
1)
The filter is clogged.
Clean the filter.
2)
Nivel de Sec. option was set to
seco
plancha/engomar
.
3)
Change Nivel de Sec. option to a higher lev‐
el.
The load was too large. Do not exceed the maximum load size.
The airflow slots are clogged. Clean the airflow slots at the bottom of the
appliance.
There is some dirt on the humidity sensor in
the drum.
Clean the front surface of the drum.
The dryness level was not set to the desired
level.
Adjust the dryness level.
4)
The condenser is clogged.
Clean the condenser.
2)
The loading door
does not close
The filter is not locked into position. Put the filter in the correct position.
Laundry is trapped between the door and
the seal.
Remove trapped items and close the door.
It is not possible to
change the program
or option.
After a cycle starts it is not possible to
change the program or option.
Turn the tumble dryer off and on. Change
the program or option as required.
It is not possible to
select an option. An
acoustic signal is
emitted.
The option you tried to select is not availa‐
ble for the selected program.
Turn the tumble dryer off and on. Change
the program or option as required.
Unexpected duration
time appears on the
display.
The drying duration is calculated according
to load size and dampness.
This is automated - the appliance is working
correctly.
A program is inac‐
tive.
The water container is full. Drain the water container, push the Inicio/
Pausa button.
2)
The drying cycle is
too short.
The load size is small. Select a time program. The time value must
be related to the load. To dry one item or a
small amount of laundry we recommend
short drying times.
The laundry is too dry. Select an appropriate time program or a
higher dryness level (e.g.
extra seco
)
ENGLISH 53
To Next Page
Loading...
