AEG voxtel c110 - Telephone Operations; Making and Answering Calls

7
UK
tPress the store button to confirm.
>The “minute” icon will be blinking.
tPress the up or down button
to set the minute.
tPress the store button
to confirm the setting.
>The display shows ‚ “SET 2 LCD”, you can continue with programming, or press the delete button
to return to standby mode.
7.2 Set LCD contrast
tIn standby mode, press the store button
.
>The display shows “SET 1 DATE”.
tPress the up or down button
until the display shows “SET 2 LCD”.
tPress the store button
to confirm.
tPress the up or down button
to select your comfortable display viewing level (1~8).
>The default setting is 4.
tPress store button
to confirm the setting.
>The display shows “SET 3 FLASH” you can continue with programming, or press the delete
button
to return to standby mode.
7.3 Set flash time
This telephone gives you the possibility to use the special services of your network provider.
When pressing the recall button
, the phone generates a line interruption and the length depends
on your flash time setting.
The default value is 100ms,which is correct for most exchanges and should not need changing, but if
the phone is connected to a PBX that requires a different timing, there are options for 300ms, 600ms
or 1000ms.
tIn standby mode, press the store button
.
>The display shows “SET 1 DATE”.
tPress the up or down button
until the display shows “SET 3 FLASH”.
tPress the store button
to confirm.
tPress the up or down button
to select 100.
>(default),300, 600, or 1000.
tPress the store button
to confirm the setting.
>The display shows “SET 1 DATE”, you can continue with programming, or press the delete button
to return to standby mode.
8 TELEPHONE OPERATIONS
8.1 Making a call
tLift the handset or press the speakerphone button
and listen for a dial tone.
>The display shows “00-00”.
tDial the telephone number you wish to call.
>The display shows the number as you dial (maximum of 14 digits)
tTo end the call, return the handset to the base unit or press the speakerphone button
if
speakerphone is selected.
OR
you can pre-dial the number and check it on the display before dialling it.
tKey in the telephone number you wish to call.
>The display shows the number as you dial, and if you make a mistake you can press the delete
button
to delete the last digit.