AEG voxtel c110 - Call Management Features; Redialing and Call Lists

88
tWhen you have entered the full number (maximum 32 digits), lift the handser or press the
speakerphone button
or dail button on the base,and the number will dial out automatically.
tTo end the call, return the handset to the base unit or press the speakerphone button
if
speakerphone was selected.
8.2 To answer a call
When the phone rings;
tLift the handset or press the speakerphone button
on the base unit.
>The call timer starts after going on line and the speakerphone light will turn on if speakerphone
is selected.
8.3 To adjust the speakerphone volume
During a call;
Adjust the volume of the speakerphone to your comfortable volume level using the speakerphone
volume slide control
located on the right side of the base unit.
8.4 To end a call
tReplace the handset on the base unit cradle or press the speakerphone button
on the base unit.
>The speakerphone light indicator will turn off.
8.5 To switch between the handset and the speakerphone
During a phone conversation through the handset, press the speakerphone button
to speak hands-
free.
The conversation remains through the handset until the handset is replaced on the base unit cradle.
Then the speakerphone light will turn on. While in speakerphone mode, lift the handset to switch off
the speakerphone and talk if through the handset.
8.6 Last number redial
tLift the handset or press the speakerphone button
on the base unit.
tPress the redial button
.
>The phone automatically dials the last number you called (maximum of 32 digits).
Automatic redial
If the number you have called is busy, you can redial it automatically by simply pressing the dial button
, which will release the current call, wait a few seconds and then redial the last number.
8.7 Outgoing call list
The Voxtel C110 automatically stores the number (up to 16 digits) and duration of the last 10 calls
made.
8.8 Viewing the outgoing call list
tIn standby mode, press the out button
.
>The display shows the most recent dialled call and its position in the outgoing calls list.
>If there are no outgoing records, the display will show “End”.
tPress the out button
again to show the duration of that call.
>Press the out button
repeatedly to step through each call record in turn.
8.9 To redial a call
tWhen the outgoing record is displayed. Lift the handset or press the speakerphone
or dail
button on the base unit.
>The phone automatically dials out the displayed record.