8
6 INSTALLATION
6.1 Connecting the base station (see P5)
• Plug the power supply and line cord into the base station.
• Plug the power adapter into a 100-240 Vac 50/60Hz mains socket
and the line cord into your telephone line socket.
Warning:
Use only the provided adaptor, using other power supplies may cause
a hazard or damage the phone.
Install the base unit in a position where the mains adapter plug will
reach an easily accessible mains socket to unplug in case needed.
Never try to lengthen the mains power cable.
Note:
The base unit needs mains power for normal operation, not just
for charging the handset batteries.
6.2 Installing and charging the batteries (see P3)
• Place the 2 supplied batteries into the battery compartment
with the polarity markings. Use only the NiMH rechargeable
battery type provided with the telephone.
• Position the battery compartment cover over the batteries and slide
up to click into place.
• Put the handset on the base and charge for 24 hours before using
the handset for the rst time.
> The handset will give a beep when it is properly placed on the
base or charger.
To Next Page
Loading...
