22
Start charging
The “Charge” LED (10) will light up.
will light up and the “Charge” LED (10) goes out.
Note:
switch to trickle charge to maintain the charging
Use jump start function (jump start mode)
The charger’s jump start function (13) can be used
jump starting.
1. Connect the charger as described under “Con-
necting The Device”.
2.
jump start mode 12V/100A (13).
started.
Note:
after approx. 30 seconds to prevent damage to the
device.
Attention!
Do not turn the ignition for more than 5 seconds at
a time.
3.
Note:
4. Jump starting mode will be disabled for 3
second countdown.
5.
plug from the 230 V mains socket.
6. Disconnect the black (-) terminal connection
terminal.
7. Disconnect the red (+) terminal connection cable
Switching the display
following parameters:
V = charging voltage
A = charging current
Switching battery types
maintenance-free lead-acid batteries (MF) and
AGM = absorbed glass mat batteries
Completing charging and disconnecting the
charger
1. First, remove the plug from the 230V power
socket.
2. Disconnect the black (-) terminal connection
3. Disconnect the red (+) terminal connection cable
To Next Page
Loading...
