Water/Methanol Injection V220
© 2020 AEM Performance Electronics
OPTIONAL SYSTEM UPGRADES
Water/Methanol Injection FAILSAFE Device – AEM P/N 30-3020/30-3020M
Actively monitors the entire flow curve independent of
pressure, continuously collecting flow vs. injection rate
data so that any deviation from your established flow
curve will trigger an alarm output that can be used to
reduce boost or timing, change maps, add fuel, trigger a
two-step, or perform practically any action you choose to
save your engine. It is PC programmable (with USB
connectivity) which eliminates the guesswork when
setting min/max threshold parameters. HIGHLY
RECOMMENDED for all water/methanol injection
systems.
Water/Methanol Injection Flow Gauge – AEM P/N 30-5141/30-5142
Displays flow rate data on a smooth moving needle-type
gauge that allows you to accurately monitor the status of
your injection system in real time. Available in max flow
rates of 500 cc/min or 1000 cc/min with a black or white
face. The AEM water/methanol injection filter is HIGHLY
RECOMMENDED when using this flow gauge.
Water/Methanol Injection Filter – AEM P/N 30-3003
Inline filter that uses a micronic mesh screen to filter out
particles as small as 40 microns. Allows a cleaner flow of
water/methanol into the injection pump, lines, and
nozzles increasing overall system longevity. Injection
filter is HIGHLY RECOMMENDED when using the AEM
water/methanol injection flow gauge.
Additional Nozzle Kit – AEM P/N 30-3315
Includes one complete nozzle, three pintle sizes (one is
preinstalled), one retaining clip, and the necessary
hardware to run a second nozzle in your injection system.
5-Gallon Tank – AEM P/N 30-3320
Upgrade to a 5-gallon tank to maximize your fluid holding
capacity. Includes level sensor and mounting hardware.
To Next Page
Loading...