aeno.com/documents 9
harmful for the environment. For more information on proper disposal,
please contact your local waste collection and disposal company. Keep
children away from the device. There is a risk of serious injury and electric
shock. This device is intended for use by adults only.
Warnings, precautions, and instructions contained herein may not contain
every possible hazardous situation. Please use common sense when operating
the device.
Initial Setup
Before the operation, you should remove the packaging from the HEPA filter.
To do this, please turn the purifier upside down and remove its cover by
turning it counterclockwise (See Figure b). Then, remove the HEPA filter from
the device body using the fabric strips (See Figure c), remove the filter
packaging, and insert the filter back into the device body. Tighten the cover by
turning it clockwise (See Figure d). After that, you should connect the air
purifier to the source of power (mains socket) using the power adapter
included in the package of supply. The power connector of the adapter must
be inserted into the power port in the device casing, while the plug of the
adapter – into the mains socket.
ATTENTION! Never use a non-original power adapter to connect to and power
on the device, as this may damage the purifier.
Button Panel Control
The purifier will be switched to the Standby Mode upon connection to the
mains socket using the power adapter. The control panel of the device
contains the following 6 LED buttons (See Figure e):
POWER button used to switch the purifier from the Standby Mode to the
Operation Mode, as well as to turn off the purifier, or turn on the anion filter.
To Next Page
Loading...