13
Tap "+" or "Add device" on the home screen of the app. In the window that
opens, select the "Vacuum Cleaner" category.
Note: If the system prompts you to turn on some features on your smartphone,
follow the recommendations in the prompts.
Enter your Wi-Fi network name and password if the fields had not been filled
automatically. Make sure that the AP mode is selected in the upper right
corner.
Press and hold the "Start/Stop" button on the control panel of the vacuum
cleaner until the Wi-Fi indicator starts blinking. Then check the "Make sure
the LED indicator is blinking" box on the Connection Instructions screen and
tap "Next".
Connect your smartphone to the Wi-Fi hotspot named "Smart Life – XXXX".
Go back to the app and tap "Connect".
Wait for the "Device successfully added" message to appear.
Note: The device can also be operated via voice assistants. Detailed information
is available in the complete operation manual at aeno.com/documents. If the
connection fails, make sure the device is plugged into a power source, turned
on and charged, check the router's Wi-Fi settings at https://aeno.com/router-
help, and then repeat the connection process.
Wet Cleaning Using Water Tank
Attach the mop for cleaning ❿ to the bottom of the water tank ⓫ (See Figure e).
Turn the water tank over, open its cover and fill the tank in with clean water for at
least 2/3 of its capacity. Then, close the cover (See Figure f). Press the dust
container lock ⓭ (See Figure b), and pull the dust container ❻ out of the vacuum
cleaner body. Then, replace it with the water tank (See Figure g). The vacuum
cleaner is ready for wet cleaning. Additionally, you may control the water supply
via the AENO mobile application.
Dust Bag Replacement
To Next Page
Loading...
