14
Unplug the power first, then open the lid of docking station (See Figure c). Take
the handle of the dust bag and pull it upwards, then throw the dust bag into the
trash. Take a new dust bag from the pacakge and insert the cardboardof dust bag
into the card slot on docking station, then push it to the end. Check the handle of
the dust bag, make sure the handle is put to the end of the slot, and the suction
port on the cardboard is open. Close the lid. Plug the power and start to use again.
Make sure that the indicator flashes white slowly.
Docking station indicator Status
White indicator flashes slowly
White indicator keeps on.
Docking station is vacuuming.
Dust bag is not placed properly.
Red indicator flashes slowly.
Suction pipe or port are blocked.
Maintenance
You may rinse side brushes ❼ with hot water or clean them up with a damp cloth.
To clean the dust container ❻, pull it out of the vacuum cleaner body by pressing
the dust container lock ⓭. Then, open the container and shake out dust and
debris into the basket (See Figure h). Open the latches and remove the pre-filter
mesh from the dust container, as well as the HEPA filter ❽ and the foam filter ❾.
Clean them all with a brush or a dry cloth. The water tank, the mop for cleaning
and the foam filter may be washed with water. The roller brush may be cleaned
after removing it from the device body by releasing the two latches.
ATTENTION! The water container is filled with distilled water only. Once wet
cleaning is completed, the water container should be first emptied of the
remaining water and left to dry.
Never rinse the dust container or the HEPA filter with water.
Troubleshooting
1. The vacuum cleaner does not turn on. Possible causes and solutions: Make
sure the power switch ⓮ is turned on, and that the vacuum cleaner or the
To Next Page
