Aeotec MULTISENSOR 6 - Adding to Z-Wave Network

29-09-2020 17:00Multisensor 6 user guide : Aeotec Group
Pagina 4 van 13https://aeotec.freshdesk.com/support/solutions/articles/6000057073-multisensor-6-user-guide-
Note: MultiSensor 6 can be powered by a single CR123A, though batteries will require changing more frequently. If
powering your MultiSensor 6 with a sole battery, insert it into the battery holder marked 1.
WARNING: Not compatible to rechargeable CR123A batteries (3.7V)
3. Make sure to seat the Battery Cover back onto the MultiSensor 6 and lock it in.
Adding your MultiSensor 6 into a Z-Wave Network.
With it powered on, it's now time to add your MultiSensor 6 to a Z-Wave network. To pair MultiSensor 6, you are not
limited to only the Z-Stick or Minimote. You may use any Z-Wave Gateway to pair MultiSensor 6, but compatibility
and how the sensor shows ultimately depends on the gateway and software integration of products.