Aeotec NanoMote Quad User Guide

1. Press and hold the NanoMote button (can be any button) for 20 seconds.
LED will change from:
Orange
Green
Red
Pink
Red
2. Release the button on the second Red LED status. It will remain red for 2 seconds
3. Tap button again while second Red LED is illuminated (you'll have 2 seconds to do so).
Advanced Parameter Configurations.
Not all gateways will allow you to further configure your Z-Wave devices, but in the case that your gateway does allow
it, the NanoMote Quad has some available parameter configurations that will allow you to configure it further to your
liking.
Parameter 32 Level of low battery.
Available settings: 10-50 (10% - 50%)
Default setting: 20 (20%)
Parameter size: 1[byte]
Parameter 42 Setting the duration value of the command switch multilevel.
Available settings: 0-255
Default setting: 255
Parameter size: 1[byte]
Parameter 43 Enable/disable the buzzer alarm when battery is running low.
0 - Disable.
1 –Enable.
Default setting: 0
Parameter size: 1[byte]
Further steps for different Z-Wave Gateways.
Most gateways will have specific steps to use NanoMote Quad via group association (direct control), while others will
have different steps to use its scene triggers through the gateway directly for more advanced controls. Below are the
known steps required for the listed gateways.
1. Currently none listed at this time. This section will update later in the future.
If your gateway is not listed here, please contact support to see if there are possible steps that can be used on your
Nano Mote Quad User Guide : Aeotec Group
https://aeotec.freshdesk.com/support/solutions/articles/6000184696-n...
7 z 9
9. 9. 2019, 15:53

Aeotec NanoMote Quad Specifications

General

Brand	Aeotec
Model	NanoMote Quad
Category	Switch
Language	English