EasyManua.ls Logo

Aerco INN600 - Over-Temperature Limit Switch Adjustment

Aerco INN600
206 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Innovation Water Heaters Installation, Operation & Maintenance Manual
CHAPTER 4 – INITIAL START-UP
OMM-0078_0L AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 Page 65 of 206
GF-128 Phone: 800-526-0288 PRI: 11/25/2014
4.7 OVER-TEMPERATURE LIMIT SWITCHES
The unit contains both automatic and manual reset over-temperature limit switches, shown in
Figure 4-6. They can be accessed by opening the front panel door of the unit.
The manual reset switch is not adjustable and is permanently fixed at 190°F. This switch will shut
down and lock out the heater if the water temperature exceeds 190°F. Following an over-
temperature condition, it must be manually reset by pressing the RESET button before the heater
can be restarted. The automatic reset over-temperature switch is adjustable and allows the unit to
restart, once the temperature drops below its temperature setting. Set the automatic over-
temperature switch to the desired setting.
Figure 4-6. Over-Temperature Limit Switch Location
MANUAL RESET (NON-
ADJUSTABLE) OVER-
TEMPERATURE LIMIT
SWITCH
AUTOMATIC RESET
(ADJUSTABLE) OVER-
TEMPERATURE LIMIT
SWITCH

Table of Contents