AERMEC DI24 - Page 25

25
QR- code
Scan the following QR- code for the APP operating manual:
CONTROL VIA AERSUITE
The AerSuite application allows remote control of the DI24 user interface, with VMF-E19/VMF-E19I thermostats, via Smart Devices with iOS and Android
operating systems. It is an application for Smartphones and Tablets with which the user will be able to remotely access and manage the operation of their
system. For more information on the use of the application and available functions, please refer to the respective documentation in the Qr-code shown.
Parameter index Parameter name Range of values Description
P6 FS2 33 - 66 % Fan speed in V2 mode
P7 FS3 66 - 100 % Fan speed in V3 mode
P8 AIR PROBE 0 - 2
0. Local ➞ Using the air probe in the user
interface
1. Thermostat ➞ Using the air probe in the
fancoil on-board thermostat
2. Average ➞ use the average value given by the
ara probes present
P9
AUX 0 - 1
0. Disabled ➞ AUX mode cannot be selected
1. Enabled ➞ AUX mode can be selected
P10 FLP 0 - 101 %
Value of the ap position in the GLF_M/GLFI_M
grids, if FLP = 101 the louvers swing function is
enabled.
P11
ATA -5.0 - 5.0 C
Parameter for air reading correction via
probe in panel
P12 CFU 0 - 1
Temperature unit selection:
0. °C ➞ °C
1. °F
➞ °F
P13 TFO 0 - 1
0. Static display
➞ Disabled
1. Dynamic display
➞ Enabled
P14 TSP 0 - 1
Set point display mode if an external
supervisor is present:
0. Absolute
➞ Actual setpoint
1. Dierential
➞ Deviation
P15 WIFI 0 - 2
0. Wi OFF
➞ Wi module o
1. Wi ON
➞ Wi module on in client mode
2. Hotspot
➞ Wi module on in host mode
(only when conguring the App)
EN