Need help?Do you have a question about the AERMEC HMI-1 and is the answer not in the manual?
General| Brand | AERMEC |
|---|---|
| Model | HMI-1 |
| Category | Controller |
| Language | English |
Displays the current status and provides access to basic functions via touch icons.
Details the menu structure, icons, and their corresponding functions for system navigation.
Instructions on how to power the unit on and off, including memory settings.
Guide on how to access different menu sections and navigate within them.
Configuration of operational modes like Heat, Cool, Hot Water, and their combinations.
Settings for quieter operation and energy-saving based on external temperature.
Configuration for weekly timers, holiday settings, and disinfection cycles.
Settings for general timers and temperature-based timer functions.
Emergency mode activation and its conditions.
Holiday mode and preset mode configurations for daily operation.
Functions for error reset, WiFi reset, loading defaults, child lock, and DST.
Lists available parameters, their ranges, and default values for system configuration.
Details functions for unit operation logic, component setup, and accessory configuration.
Setting control logic and status for 2-way valves in cooling and heating modes.
Configuration of water tank presence and external thermostat management.
Setting up and managing an additional heat source with different logic options.
Configuration for optional electric heaters and activation of air removal function.
Setting up a pre-heating procedure for radiant panels with defined segments and times.
Setting force modes and configuring the unit's serial address for Modbus control.
Managing refrigerant recovery and setting logic for the electric tank heater.
Configuring hot water control modes and the Smart Grid function.
Setting the maximum temperature for water heating by the heat pump.
Displays the operational status of various components like compressor, fan, and valves.
Displays status of parameters such as temperatures, pressures, and set-points.
Lists current errors and alarms active on the unit with their codes and descriptions.
Displays monthly and yearly power consumption data through bar charts.
Configures temperature units, beep settings, back light, and time/date.
Information on managing the unit via a BMS connected via ModBus RS485.
To Next Page
