Need help?Do you have a question about the AERMEC Multichiller-Evo and is the answer not in the manual?
Describes the recommended system setup with storage tank and circuit breaker.
Shows the electrical connections for installing the Multichiller-Evo accessory.
Summarizes probe connections based on unit type and selected functions.
Explains how to navigate through menus using icons and the touch screen.
Details basic operations for navigating menus and application pages.
Represents the home screen displaying chiller status and system overview.
Displays values read from selected chiller's probes and transducers.
Allows enabling/disabling chillers and resetting active alarms.
Allows setting system ON/OFF, parameters, and time programs.
Configures recovery side functioning settings for multipurpose units.
Allows setting date and time for the system and touch display board.
Displays real-time charts of values read by system side probes.
Allows selection of the system interface language.
Process for entering the password to access the installer menu.
Configures parameters for fixed threshold logic in chiller management.
Allows setting a backup chiller for system redundancy.
Manages system changeover between cooling and heating modes.
Allows selection and application of measurement units for system management.
Configures climatic curve settings using voltage or current input.
Configures power demand/limitation using voltage or current input.
Sets power demand/limitation for the recovery side of the system.
Displays software versions for the main board and touch screen.
Configures Modbus library and addresses for connected chillers.
Enables/disables probe reading for NSM family chillers.
Process for entering the password to access the manufacturer menu.
Displays currently active alarm conditions on the unit.
Describes the recommended system setup with storage tank and circuit breaker.
Shows the electrical connections for installing the Multichiller-Evo accessory.
Summarizes probe connections based on unit type and selected functions.
Explains how to navigate through menus using icons and the touch screen.
Details basic operations for navigating menus and application pages.
Represents the home screen displaying chiller status and system overview.
Displays values read from selected chiller's probes and transducers.
Allows enabling/disabling chillers and resetting active alarms.
Allows setting system ON/OFF, parameters, and time programs.
Configures recovery side functioning settings for multipurpose units.
Allows setting date and time for the system and touch display board.
Displays real-time charts of values read by system side probes.
Allows selection of the system interface language.
Process for entering the password to access the installer menu.
Configures parameters for fixed threshold logic in chiller management.
Allows setting a backup chiller for system redundancy.
Manages system changeover between cooling and heating modes.
Allows selection and application of measurement units for system management.
Configures climatic curve settings using voltage or current input.
Configures power demand/limitation using voltage or current input.
Sets power demand/limitation for the recovery side of the system.
Displays software versions for the main board and touch screen.
Configures Modbus library and addresses for connected chillers.
Enables/disables probe reading for NSM family chillers.
Process for entering the password to access the manufacturer menu.
Displays currently active alarm conditions on the unit.
General| Model | Multichiller-Evo |
|---|---|
| Manufacturer | AERMEC |
| Protection Rating | IP20 |
| Type | Controller |
| Compatibility | AERMEC chillers |
| Display | LCD |
| Communication Protocol | Modbus |
| Power Supply | 24 Vac |
| Humidity Range | 5% to 90% RH (non-condensing) |
To Next Page
