5
IFCLTY 1112 - 4528511_04
The fan coils are shipped in standard
package which consists of expand-
ed polystyrene foam and cardboard
shells.
PACKAGE
WARNING: the fan coil is connected
to the power supply and a water cir-
cuit. Any operation by persons who
do not possess the required technical
skills can lead to personal injury to the
operator or damage to the unit and
surrounding objects.
POWER THE FAN COIL ONLY WITH
230V, SINGLE-PHASE VOLTAGE
Any other type of power supply could
permanently damage the fan coil.
DO NOT USE THE FAN COIL IMPROP-
ERLY
Do not use the fan coil for animal hus-
bandry applications (e.g. incubation).
AIR THE ROOM
Periodically air the room in which the
fan coil has been installed. This is par-
ticularly important if the room is occu-
pied by many people, or if gas appli-
ances or sources of odours are present.
ADJUST TEMPERATURE ADEQUATELY
The room temperature should be adjust-
ed in order to provide maximum com-
fort to the people in the room, espe-
cially if they are elderly, children or
sick people; avoid differences over 7°C
between the outdoor temperature and
the temperature inside the room in
summer.
In summer, a temperature that is too low
causes higher electrical consumption.
CORRECTLY ADJUST THE AIR JET
Air coming out from the fan coil must
not reach people directly; in fact, even
if the air is warmer than the room tem-
perature, it could cause a cold sensa-
tion and result in discomfort.
DO NOT USE EXCESSIVELY HOT
WATER
Clean the fan coil with a soft cloth or
sponge soaked in water not over 40°C.
Do not use chemical products or sol-
vents to clean any part of the fan coil.
Do not spray water on the outer or
inner surfaces of the fan coil (it might
cause short circuits).
CLEAN THE FILTER PERIODICALLY
Cleaning the filter frequently guarantees
enhanced operating efficiency.
Check whether the filter is very dirty: in
this case, clean it more often.
Clean frequently; remove the accumu-
lated dust with a vacuum cleaner.
Once the filter is clean, refit it on the fan
coil following the removal instructions
but in reverse order.
SUPPLEMENTARY CLEANING
The fact that the blades of examinable
shrouds can be removed (operation
done only by adequately skilled techni-
cians) ensures a thorough cleaning of
the internal components, which is par-
ticularly important when installing the
unit in crowded areas or venues requir-
ing high hygiene standards.
DURING OPERATION
Always leave the filter fitted on the fan
coil during operation (otherwise dust in
the air could soil the coil surface area).
WHAT IS NORMAL
In cooling mode, water vapour may be
present in the air delivery of the fan
coil.
In the heating mode, a slight hiss
might be heard close to the fan coil.
Sometimes the fan coil might give off
unpleasant smells due to the accumula-
tion of substances present in the air of
the room (clean the filter more often,
especially if the room is not ventilated
regularly).
While the unit is functioning, there
could be noises and creaks inside
the device due to the various thermal
expansions of the elements (plastic and
metal), but this does not indicate any
malfunction and does not damage the
unit unless the maximum input water
temperature is exceeded.
MALFUNCTION
In the event of a malfunction, cut off
power supply to the unit, then restore
the power and start the unit again.
If the problem occurs again, call the
local After-Sales Service immediately.
DO NOT TUG THE ELECTRIC CABLE
It is very dangerous to pull, tread on or
crush the electric power cable, or fix it
with nails or drawing pins.
A damaged power cable can cause short
circuits and injure people.
DO NOT OBSTRUCT THE AIR
OUTLETS BY PLACING OBJECTS
INTO THEM
Do not put anything in the air outlet
slots.
This could injure people and damage
the fan.
IMPORTANT INFORMATION AND MAINTENANCE
To Next Page
Loading...
Need help?
General
