AERMEC FCL 64 - Accessory Details: Temperature Probes; VMF-SW1 Water Temperature Probe (Cold Water); SW3 Minimum Water Temperature Sensor; SW4 Water Temperature Probe (2-pipe;Hot Water)

58
IFCLTY 1112 - 4528511_04
VMF-SW1 WATER TEMPERATURE PROBE FOR:
- COLD WATER CIRCUIT IN 4-PIPE SYSTEMS
ACCESSORIES
SW4 WATER TEMPERATURE PROBE FOR:
- 2-PIPE SYSTEMS
- HOT WATER CIRCUIT IN 4-PIPE SYSTEMS
SW4
Water temperature probe for VMF System thermostats to be used in:
- 2-pipe systems
- the hot water circuit in 4-pipe systems
VMF-SW1:
Water temperature probe for VMF System thermostats to be used in:
- the cold water circuit in 4-pipe systems
VMF-SW1:
SW3 MINIMUM WATER TEMPERATURE SENSOR
SW3 water temperature probe acces-
sory
to be used with the PXAE control
panel
.
It detects the water temperature in the
heating coil, to prevent the fans from
operating when the water temperature
is lower than 35°C. The SW3 sensors
are fit for 230V single phase power
supply.
The probe is equipped with a 2.5 metre
length cable.
2,5 m
SWA MINIMUM WATER AND AIR TEMPERATURE PROBE
SWA external probe accessory for FMT20AW control panels.
- The probe detects the temperature of the ambient air if
connected to the connector (A) of the FMT20AW panel; the
ambient air temperature probe incorporated in the panel is
automatically deactivated.
- Detects the temperature of the water in the system for
ventilation consent, if connected to the connector (W) of the
FMT20AW panel.
Two SWA probes can be connected to the panel FMT20AW
simultaneously.
The probe is equipped with a 6 metre length cable.
6 m
0,7 m