OMNIA UL C FANCOIL
The OMNIA UL C fancoil combines advanced technological
and operational characteristics that make it the ideal unit for air
conditioning any room.
Treated air is immediately delivered to the entire room; the
OMNIA UL C produces warm air when fitted to a heating system
with boiler or heat pump, but can also be used during the sum-
mer season as an air-conditioning unit (if the main system is
also equipped with a water chiller).
The filter is easy to remove and is made of materials that can
is switched off the fins close, thereby preventing dust and
foreign matter from entering the unit.
The removable drip tray and fan volute ensure thorough clea-
ning of the unit (by specifically trained personnel), essential for
installations in venues subject to crowding or in those with spe-
cial hygiene requirements.
The new centrifugal fan assembly is so quiet that during stan-
dard operation it's virtually impossible to hear when the OMNIA
UL C starts up. And the use of electronic control panels elimina-
tes the annoying noises typical of mechanical thermostats.
The electronic thermostat is protected by a panel on the unit
head. that is used
Electronic temperature control, automatic fan speed switcho-
ver, automatic season switchover and start-up - automatic
shutdown.
designed to satisfy all installation types.
It is easy to install and the water connections can be reversed
during installation.
Full compliance with safety regulations.
Routine maintenance is limited to periodic cleaning of the air
filter in water.
10
A
B
C
COMMANDS AND VISUALISATION
The fan coil is switched off. It may however start again in
below 7°C and the water temperature is suitable; in this case the
red LED flashes. To start the fan coil, turn the knob towards the
functioning mode required in the AUTO position or in one of the
three ventilation speeds.
The thermostat maintains the set temperature by chang-
ing the fan speed in Automatic Mode in accordance with the
room temperature and the set temperature..
V1 In this position, the minimum ventilation speed stays active
regardless of thermostat requests.
V2 In this position, the minimum ventilation speed stays active
regardless of thermostat requests
V3 In this position, the minimum ventilation speed stays active
regardless of thermostat requests
In this position the minimum ventilation speed V1 remains
active.
Selection of the desired room temperature.
-
tronic thermostat and if the heating system is able to satisfy the
request
Indicates the ventilation request by the electronic thermostat.
Flashing indicates the stand-by status
To Next Page
Loading...
Need help?
General
