9
GENERAL INFORMATION
Introduction
This is the user manual for the 3030A, 3030C, 3035, 3035C and 3036 Wideband RF
Digitizers, which are referred to generically in this document as ‘3030 Series’.
These digitizers operate over the following frequency ranges:
3030A 330 MHz to 3.0 GHz
3030C 250 kHz to 3.0 GHz
3035 330 MHz to 6.0 GHz
3035C 250 kHz to 6.0 GHz
3036 250 kHz to 13.0 GHz
Applications
3030 Series RF Digitizer modules down-convert and digitize RF signals. They convert an
analog RF waveform presented at the RF port into a series of amplitude- and phase-corrected
digital IF or IQ data pairs at the rear-panel PCI and front-panel data interfaces. Software
supplied with the module allows for spectrum analysis of the digitized signals.
3030 Series RF Digitizer modules can be used in RF test and measurement systems used in
development or manufacturing. Applications span all areas of radio communications.
Input range and accuracy
Input level control is provided by electronic switched attenuation, which helps to maximize
the usable dynamic range. Good level accuracy and repeatability make the module ideal for
high-volume manufacturing.
To Next Page
Loading...
Need help?
General
