1
WARNING
&1
Repair
Falling
Over
2
For Safety
IWARNING
6 I
1.
ALWAYS refer to the operation manual when
working near locations at which the alert mark shown
on the left is attached.
If
the operations are
performed
without
heeding
the advice the
operation
manual,
there
is
a risk
of
personal injury. In addition,
equipment performance may be reduced. This alert
mark
is
sometimes used with other marks and
descriptions indicating other dangers.
2.
When supplying power to this equipment, connect the
accessory 3-pin power cord to a 3-pin grounded power
outlet.
If
a grounded 3-pin outlet is not available, and
before supplying power
to
the equipment, use a conversion
adapter and ground the green wire, or connect the frame
ground on the rear panel
of
the equipment to ground.
If
power is supplied without grounding the equipment, there
is a risk
of
receiving a severe
of
fatal electric shock or
equipment damage.
3.
The user cannot repair this equipment.
DO
NOT
attempt to open the cabinet or to disassemble internal
parts.
Only IFR trained service personnel or staff from
your sales representative with a working knowledge
of
electrical fire and shock hazards should service this
equipment. There are high-voltage parts in this
equipment that present a risk of severe injury or fatal
electric shock to untrained personnel.
In
addition, there
is
a risk
of
damage to precision parts.
4. This equipment should be used
in
the correct position,
If
the cabinet is turned on its side, etc., it can be unstable and
may be damaged
if
it
falls over as a result
of
receiving a
slight mechanical shock.
To Next Page
Loading...
Need help?
General
