DURATI battery-powered shearing machine
6
– national regulations on fire and explosion protec-
tion.
– operating advisories according to IEC-/VDE regu-
lations.
5. Working with the DURATI
battery-powered shearing
machine and charger XT433/
Li-ion battery XT431
5.1 System set-up
5.1.1 Connecting the accessories
Combinations of accessories that are not mentioned in
the present instructions for use may only be employed
if they are specifically intended for the respective
application, and if they do not compromise the perfor-
mance and safety characteristics of the products.
5.1.2 Attaching the Blade
Note
The shearing head GT330 #10 for the DURATI battery-
powered shearing machine is included in the scope of
delivery. Various shearing heads are available for dif-
ferent applications!
Fig. 1
¾ If knife hinge is closed: Open knife hinge 17 with
screwdriver, see Fig. 1.
Fig. 2
DANGER
Fire and explosion hazard!
¾ Do not operate the product in
explosion-hazard areas.
CAUTION
Malfunction of, or damage to the
product caused by improper setup!
¾ Do not expose the product to
direct sunlight or moisture.
¾ Do not cover the ventilation
slots of the product.
¾ Connect the product to power
mains with a voltage range of
100 V to 240 V and a frequency
range of 50 Hz to 60 Hz.
¾ Ensure that the mains power
socket used for supplying the
product is freely accessible.
WARNING
Risk of injury caused by sharp cut-
ting plates!
¾ Handle the shearing head of the
DURATI shearing machine care-
fully.
17
12
17
To Next Page
Loading...