TROUBLESHOOTING AND FAULT REPAIR (Cont.)
Flat tire and unstable
driving.
Low air pressure.
Puncture.
Pump to normal pressure.
Repair the tire.
The Display Flashes and
the vehicle does not move.
Controller Coded
Fault.
Ask for technical Assistance.
Manual Mechanical Brake
Lever is fully pressed but
the vehicle does not stop.
Loose hand brake
mechanism.
Tighten the brake cable.
When releasing the speed
lever on level surface , the
Breeze C does not stop at
regular distance or more
than 3 meters
Not adjusted or faulty
controller.
Ask for technical
assistance.
The Key Switch is turned to
“ON” (clockwise), but the
“ON” light does not come
on.
Main fuse popped
out or electrical fault .
(See 2.1a in Figures 1 or
2 )
Reset fuse Note:Do not reset
fuse more than twice. If the symptom
recurs after resetting the second time,
call the authorized dealer for support.
Breeze C does not move
when squeezing the
Operating Lever .
Main Key Switch is in
OFF position.
Charging Plug is
installed in
Charging Socket.
The Mechanical
Release Lever of the
electromagnetic Brake is
operated .
Control system failure.
Turn the key to “ON” position.
Disconnect the Charging Plug
from the Breeze C.
Remove lever to engaged position
.
Call for technical support.
Battery capacity low.
Failed connections
Faulty battery.
Charge batteries for at least 18
hours.
Remove Batteries Cover and
check the battery cables connection.
In case of corrosion of the terminals,
clean the terminals with a damp clean
cloth.
If, after recharge, the red leds are
still ON, the battery may be faulty. For
replacement, contact your dealer.
RIGHT or LEFT turn signal
light is inoperative.
Faulty LED light
board.
Headlight and/or rear light
are not lit.
Replace Headlight or Rear bulb.
When driving uphill or
carrying heavy loads the
Breeze C speed is
decreased gradually but
still moving.
The
Breeze C controller
exceeded too high
temperature.
It is recommended to stop the
Breeze C and let the controller cool
for awhile.