CHAPTER 7 – MAINTENANCE
Note:
1. Maintenance Manual is available for trained technicians.
2. The numbers in parentheses refer to the parts illustrated
in figure 11.
Although the Breeze C requires minimal maintenance, do not neglect it. When servicing
the Breeze C, make sure that it stands on a level surface and that the key is not inserted.
Remark: For the periodic maintenance no special tooling is needed.
(Numbers in the table refers to figure 10)
Periodic
Maintenance
Check
Check for missing
parts and damaged
parts .Use the figures
#1,2,3,4 .
When receiving the Breeze C or after
a long time not using it.
Check air pressure in
all tires.
Every 2-3 years , after about 300-400
full cycles of charge/discharge. When
short travel distance and/or technician
check.
Note: To Replace the batteries, the Seat and Battery Cover
located under the Seat must be removed.
Removing the Seat
and the Batteries
Cover(2)
Turn the Seat by using the lifting Lever (3.2) so that the Lever will
point 45º Right or Left. The Seat can be removed only at this
position.
Remove the Seat (3): Hold the Seat in your two hands – one hand
on the backrest and a second hand at the front lower part of the seat
and lift the seat up from its pivot.
Warning! The seat weight is 15 Kg (33lbs).
Keep lifting with your Knees/legs and not loading your Back.
Release Battery Cover (5) securing screws (2.3).
Lift the Battery Cover (2) until it is released from the Seat Pivot (4).
Replacing the
Batteries Cover(2)
The replacement of the Batteries Cover is done in reverse order;
MAKE SURE that the Gray Cover (2) fits onto it’s place. Secure with
the 5 screws (2.3).
Batteries weight each ~14 Kg (~30lbs) and over.
Lift each battery only with the appropriate handle. Keep lifting with
your Knees/legs and not loading your Back.
Correct air pressure in the tires is essential for optimal steering and
stability of the Breeze C. Check air pressure every two weeks.
Inflate proper air pressure in all tires: 25±2 psi.
Use only a damp cloth and mild detergent. Never use a hose for
cleaning. This may severely damage the power and electronic
components.