AFINOX Infinity Series

Questions and Answers

V
Vincent HollandAug 19, 2025
What to do if my AFINOX Infinity Chiller shows a high condensation alarm?
- J
  Jason DiazAug 19, 2025
  If your AFINOX Chiller displays a high condensation alarm, it could be due to several reasons. The room temperature might be too high, in which case you should ventilate the room. Alternatively, the condenser might be clogged or dirty; ensure that the air intakes are not obstructed and clean the condenser if necessary. It could also be due to a condenser probe issue, a non-working condenser fan, or high inlet pressure, in which case you should call a qualified engineer and inform them of the alarm and product serial number.
J
Jose SerranoAug 21, 2025
How to fix the maintenance alarm on my AFINOX Infinity?
- J
  James ChaseAug 21, 2025
  If you're experiencing a maintenance alarm on your AFINOX Chiller, it could be due to the maximum time elapsing without maintenance or cleaning. In this case, call a qualified engineer and inform them of the alarm and product serial number. Alternatively, it may be resolved by cleaning the condenser, checking the fan operation and gasket seal, and then resetting the machine.
B
Brenda SampsonAug 23, 2025
Why is the compressor not working in my AFINOX Chiller?
- H
  hgomezAug 23, 2025
  If your AFINOX Chiller's compressor isn't working, there could be several underlying causes. These include an opening of the power line, a tripped circuit breaker, a triggered safety thermal switch, the contactor entering lock mode when opened, loose terminals, a control connection error, low line voltage, compressor motor failure, a compressor gripping fault, partial closure of the compressor inlet valve, poor refrigerant gas load, a clogged compressor suction filter, or air inside the cooling circuit. In any of these cases, you should call a qualified engineer and inform them of the read error and product serial number.
V
Valerie KingAug 26, 2025
Why is my AFINOX Infinity Chiller unit so loud?
- C
  Christopher PatelAug 26, 2025
  If your AFINOX Chiller is excessively loud, it could be due to vibration in the pipes, a hissing expansion valve, or a high compressor noise level. In any of these cases, you should call a qualified engineer and inform them of the read error and product serial number.
S
Sara NashAug 27, 2025
What to do for a low evaporation alarm on AFINOX Infinity?
- T
  Traci GarciaAug 28, 2025
  If your AFINOX Chiller is showing a low evaporation alarm, it might be caused by ice on the evaporator. To resolve this, run a defrost. Alternatively, the evaporator fan might not be working, or the evaporator probe could be damaged or broken. In either of these cases, you should call a qualified engineer and inform them of the alarm and product serial number.
J
Joshua WardAug 30, 2025
How to troubleshoot a defrost time-out alarm on my AFINOX Chiller?
- A
  Alex McdonaldAug 30, 2025
  If your AFINOX Chiller displays a defrost time-out alarm, it could be due to ice on the evaporator, in which case you should run a defrost. It could also be caused by a non-working evaporator fan or a damaged/broken evaporator probe. In such cases, you should call a qualified engineer and inform them of the read error and product serial number.
R
Rachel PierceSep 1, 2025
Why is the liquid line too hot on my AFINOX Infinity Chiller?
- J
  Jason RichSep 1, 2025
  If the liquid line of your AFINOX Chiller is too hot, it may be due to a loss of gas load from a leak or an expansion valve closing too fast. In this case, you should call a qualified engineer and inform them of the read error and product serial number.
A
amyvalenciaSep 3, 2025
What does the black-out alarm mean on my AFINOX Infinity?
- T
  Tony MartinezSep 3, 2025
  If you observe a black-out alarm on your AFINOX Chiller, it indicates that no power was supplied during the cycle. Check the electrical power supply to resolve this issue.
B
beckralphSep 5, 2025
Why is the suction line wet on my AFINOX Infinity Chiller?
- Q
  qsnyderSep 6, 2025
  If the suction line of your AFINOX Chiller is wet or covered with frost, it suggests that the expansion valve is allowing too much refrigerant gas to pass. Call a qualified engineer and inform them of the read error and product serial number.
B
Billy MitchellSep 7, 2025
Why does the compressor leak oil on my AFINOX Chiller?
- J
  John JimenezSep 7, 2025
  If the compressor of your AFINOX Chiller leaks oil, it could be because the oil electrical heater is not working during machine stops. In this case, you should call a qualified engineer and inform them of the read error and product serial number.

Summary

Installation INFINITY Trolleys

Components Required for Cell Assembly

Lists all essential components and parts required for assembling the Infinity trolley unit.

Infinity Trolley Cell Assembly Instructions

Detailed instructions for the physical assembly of the Infinity trolley cell structure.

Connecting Infinity Trolley Pipelines

Guidance on connecting the refrigerant pipelines to the unit's temperature regulator, with key recommendations.

Infinity Trolley Electrical Installation

Procedures for safe electrical installation, circuit breaker selection, and phase rotation checks.

Infinity Trolley Condensate Drain Connection

Instructions for correctly connecting the condensate water discharge pipe and its syphons.

Infinity Trolley Initial Startup and Testing

Steps for the initial startup of the Infinity trolley, including system testing and interface navigation.

Infinity Trolley Troubleshooting and Solutions

Comprehensive guide to common malfunctions, alarm signals, and their solutions for the Infinity trolley.