TROUBLESHOOTING
CLEANING
Before cleaning remove the mains lead from the socket.
Never immerse the housing with motor in water!
Do not use any sharp or abrasive detergents.
Motor Housing
Only a damp rinsing cloth should be used to clean the
outside of the housing.
Mixing Bowl, Mixing Equipment
CAUTION:
The components are not suitable for cleaning in a
dishwasher. If exposed to heat or caustic cleaners they
NO. Troubles Solution
1
The machine doesn't work
• Check if the plug is in good contact with the socket
• Check if the rise button spring back in place
• Check if the machine works continuously more than 6-
10 minutes, and wait until the motor cool down
2
Noise in the mixing bowl
when working (the accessory
scraped the bowl)
• Check if the mixing bowl is properly installed
• Check if the accessory installed properly on machine
3
The pot cover doesn’t fit the
mixing bowl properly
• Check if the pot cover placed on the machine properly
• Check if the mixing bowl installed properly on machine
and locked correctly
4
The machine doesn’t work on
certain speed
• Check if the mark on speed knob correspond to the
speed silkscreen on housing
• Rotate speed knob to 0 ,and re-check if the machine
works
5
Movements when the
machine working
• Check if the anti-slip feet fall off
• Check if the machine is placed on a smooth and flat
tabletop
6
The rise button didn’t spring
back in place after installing
the mixing bowl and pot
cover
• Check if the pot cover placed on the machine properly
• Check if the mixing bowl is properly installed
might become misshapen or discolored
Components that have come into contact with food
can be cleaned in soapy water
Allow the parts to dry thoroughly before reassembling the
device
Please apply a small quantity of vegetable oil likely to the
screens after they have dried
To Next Page
Loading...