19
Manufacturers of non Agatec accessories
The manufacturers of non Agatec accessories for the product are
responsible for developing, implementing and communicating safety concepts
for their products, and are also responsible for the effective- ness of those
safety concepts in combination with the Agatec product.
Person in charge of the product
The person in charge of the product has the following duties
• To understand the safety instructions on the product and the instructions
in the user manual.
• To be familiar with local regulations relating to safety and accident
prevention.
• To inform Agatec immediately if the product and the application
becomes unsafe.
WARNING
The person responsible for the product must ensure that it is used in accor-
dance with the instructions. This person is also accountable for the training
and the deployment of personnel who use the product and for the safety
of the equipment in use.
Hazards of Use
WARNING
The absence of instruction, or the inadequate imparting of instruction, can
lead to incorrect or adverse use, and can give rise to accidents with
far-reaching human, material, financial and environmental conse- quences.
Precautions:
All users must follow the safety directions given by the manufacturer and
the directions of the person respon- sible for the product.
CAUTION
Watch out for erroneous measurement results if the product has been
dropped or has been misused, modified, stored for long periods or
transported.
Precautions:
Periodically carry out test measurements and perform the field
adjustments indicated in the user manual, particularly after the product
has been subjected to abnormal use and before and after important
measurements.
To Next Page
Loading...