Agatec RL110 - Automatic; Manual modes; H.I. Alert mode

7
Mode RIGHT / LEFT UP / DOWN
Automatic mode - Moves CW/CCW Cycle through the
rotating mode rotating speed
Automatic mode - Moves scan Cycle through the
scanning CW/CCW scanning width
Laydown mode - Slope Cycle through the
rotating rotating speed
Laydown mode - Slope Cycle through the
scanning scanning width
Manual mode - Slope Cycle through the
rotating rotating speed
Manual mode - Slope Cycle through the
scanning scanning width
Automatic / Manual modes
The Agatec RL110 is in automatic, self-leveling mode when turned on.
Once the instrument has self-leveled, the laser head will start rotating with
600 rpm.
In manual mode, the laser does not self-level; this means that the
beam will rotate even if the laser is not leveled. It can therefore be
used on inclined planes such as stairs, roofs, or when manual grade
setting is required. See later section on setting slope in manual or
semi-automatic modes.
H.I. Alert mode
The H.I. feature stops the laser automatically if the laser is disturbed,
preventing inaccurate readings. It functions only when activated.
• To activate this safeguard feature, keep pressed the H.I. key {B-2} after
turning on the laser. The H.I. LED {B-8} will blink rapidly while the laser
is initializing the H.I. mode.