FENDT 8370 P - 8400 P - EAME 25
D3151100M5 - S/N 580000026 - S/N 580400004 - S/N 581000014 - S/N 581400007
2. Safety
Crop_this_page
2.1 Safety
2.1.1 General Safety Precautions
T005859
Every effort has been made to ensure that Fendt combines provide maximum protection against per-
sonal injury through accidents. The effectiveness of guards and other safety devices is only as com-
prehensive as the operator allows in practising caution whenever the machine is running. Reading
the simple rules below is only part of your responsibility. Memorise them and practise them until you
are continually safety conscious. In order to provide a better view, certain photographs or illustra-
tions in this manual may show an assembly with the safety shield removed. However, a machine
should never be operated in this condition. Keep all shields in place. If a shield removal becomes nec-
essary for repairs, replace the shield prior to machine operation.
Operators should familiarise themselves with the provisions of the Road Traffic Acts and of the reg-
ulations made thereunder in order to ensure that, when taking the combine and the attachments
upon the road, they comply with the relevant statutory requirements. Always remember to observe
the restrictions on the use of vehicles carrying projection loads or appliances.
The machine is delivered from the factory with guards and safety equipment as required by the au-
thorities.
2.1.2 Attention - Warning Symbols
T005852
Read Operator's Manual and safety precautions
thoroughly before starting! (Note decals on the ma-
chine!)
All persons using or involved with service or main-
tenance of this machine should familiarise them-
selves with the safety precautions!
Provisions Concerning Safety and Prevention of
Accidents
Before starting check the combine with a view to
road safety and reliability.
Note this symbol fig. 1 in this operator instruc-
tion book, it's for your own safety.
2.1.3 Safety Precautions
T006064
WARNING:
Your safety is involved!
Safety precautions are for your safety
1. In addition to the instructions stated in this operator's manual it is the responsibility of the user to observe
general safety provisions and regulations for the prevention of accidents.
2. Warnings and instructions on the machine provide important information as to safe use. They are for your
own safety and must be closely observed.
3. In road transport it is the responsibility of the user to observe the current provisions concerning forward
speed, total weight, axle load, transport dimensions, safety equipment, safety guards, warnings and
lights.
4. The operator should not drive under the influence of alcohol or drugs. Operators on prescription or over-
the-counter drugs should seek medical advice as to whether or not they are able to operate the combine
properly.
I017766
Fig. 1.
To Next Page
Loading...
Need help?
General
