What to do if my AGCO HayBoss G2 596 system does not pause at the end of a row?
If the system isn't pausing at the row's end, it could be due to: * A short in the cable: Replace the cable. * A damaged sensor: Replace the sensor. * Misaligned sensors: Check the 474 manual for alignment instructions.
Why does AGCO Farm Equipment leak product after shutdown?
If the system leaks product out of the tips after shutdown, it's likely due to dirty or defective check valves. Try cleaning or replacing them.
Why does my AGCO HayBoss G2 596 Farm Equipment pump not develop enough output?
If the pump isn't developing enough output, consider these causes: * Air leaks or clogs on the inlet side: Tighten or clean the filter bowl assembly. * Worn or dirty pump: Rebuild the pump.
General| Brand | AGCO |
|---|---|
| Model | HayBoss G2 596 |
| Category | Farm Equipment |
| Language | English |
Visual guide to the location of safety decals on the applicator.
Explanation of the meaning and purpose of various safety signs.
Instructions for safely filling the applicator tank with product.
Steps for connecting electrical harnesses and operating the main ball valve.
Overview of the Harvest Tec monitor screens and operational modes.
How to configure application rates, baling rates, and other settings.
Managing and viewing job data, including bale details and downloads.
Procedure for checking for leaks and priming the application pumps.
Configuring chemical application rates and baling parameters.
How to operate the system in automatic mode for effective application.
How to operate the system in manual mode for controlled application.
Viewing specific job details and individual bale records.
Procedure for downloading job records to a USB drive.
Using the diagnostics screen to check pump output and system performance.
Answers to frequently asked questions about system operation.
Schedule of routine checks and maintenance tasks for the applicator.
Instructions for cleaning the filter bowl and spray tips.
Procedures for tank lid, connections, pumps, battery, and valves.
Resolving problems with pump operation and product output.
Diagnosing and fixing moisture reading and flow meter discrepancies.
Troubleshooting display lock-ups, power issues, and communication errors.
Schematics for power, pump, and flow meter connections.
Details on display and sensor communication wiring harnesses.
Lists of parts for various baler installation kits (e.g., 4438B, 4439B).
Terms and conditions of the manufacturer's warranty.
Information for obtaining technical support and assistance.
To Next Page