35
4450A EN 20060221 Basic operation (‘Operator mode’)
CR 85-X DIGITIZER
Re-erasing image plates with status ‘erased’
To erase one or more image plates which have been erased as part of a normal
or emergency digitizing cycle:
1 Check that the CR 85-X is ready for operation:
• the CR 85-X must display the operator screen with ‘Ready’ or ‘Busy’ status.
• the status indicator at the top of the CR 85-X must be constant or flashing
green.
2 Press the Erase key on the keypad.
The display will read:
READY
CR 85-X
Status
READY
ERASURE
WARNING
The next cassette(s) will be erased
Enter number of cassettes to erase: #
Put cassette(s) in input buffer or
press to quit.
To Next Page
Loading...
