AGFA CR 85-X - Page 38

38
4450A EN 20060221Basic operation (‘Operator mode’)
CR 85-X DIGITIZER
Re-erasing image plates with status ‘to be erased’
To re-erase one or more image plates which you have given the status ‘to be
erased’ via the ID station:
1 Check that the CR 85-X is ready for operation:
• the CR 85-X must display the operator screen with ‘Ready’ or ‘Busy’ status.
• the status indicator at the top of the CR 85-X must be constant or flashing green.
2
Place the cassettes in the input buffer.
The CR 85-X will automatically erase the image plates. The display will read:
When the CR 85-X has erased the image plates, it displays the operator main screen.
3 Remove the cassette(s) from the output buffer.
READY
CR 85-X
Status
BUSY
* * * ERASING * * *