DX- D 600
User Manual
0242F EN 20181218
157
Table 8-8 (Cont.)
Auto-centering
CODE USER ERROR MESSAGE ERROR DESCRIPTIO N ACTION
11851
Operative rejected:
CS-Angular Target greater than 46
o
limit: Please, check POSITION
parameters
Auto-centering does not start because
final position for the Ceiling
Suspension is out of range on Alpha
Axis, greater than 46
o
Move Bucky/Detector and try again
11852
Auto-movement aborted:
The CS-Angular Axis is blocked:
Please, try again
Auto-centering does not start because
final position for the Ceiling
Suspension Alpha Axis timed out
Try again
11861
Operative rejected: CS-Rotation
Target greater than 30
o
limit: Please,
check POSITION parameters
Auto-centering does not start because
final position for the Ceiling
Suspension is out of range on Beta
Axis, greater than 30
o
Move Bucky/Detector and try again
11862
Auto-movement aborted:
The CS-Rotation axis is blocked:
Please, try again
Auto-centering does not start because
final position for the Ceiling
Suspension (slave) Beta Axis timed
out.
Try again
11871
Operative rejected: W all Stand-Vertical
Target out of calibrated range: Please,
check POSITION parameters
Wall Stand-Vertical Target out of
calibrated range
Move Bucky/Detector and try again
11881
Operative rejected: W all Stand-Tilting
Target out of calibrated range: Please,
check POSITION parameters
Auto-centering does not start because
initial position for Wall Stand Tilting is
out of specifications.
Applied to single panel usage, where
tilt must be at 90
o
Move Bucky/Detector and try again
11891
Operative rejected: Table-Longitudinal
Target out of calibrated range: Please,
check POSITION parameters
Auto-centering does not start because
final position for the Table (slave) is
out of range on Longitudinal Axis
Move Bucky/Detector and try again
11892
Auto-movement aborted:
The Table-Longitudinal Axis is
blocked: Please, try again
The Table-Longitudinal Axis is blocked Try again
11893
Auto-movement aborted:
The Wall Stand-Vertical Axis is
blocked:
Please, try again
The Wall Stand-Vertical Axis is
blocked
Try again
To Next Page
Loading...
