The built-in memory can only store a photos for testing (3MP only). The photos will not be saved when the camera
is battery low or the battery is removed. Please insert the SD memory card before use. Please refer to the following
instruction for correct installation.
Appendix B: Q&A
Q: I have taken photos but my computer does not recognize my camera. What do I do?
A: First, make sure that you have taken photos. Press the Shutter/SETbutton a few times to take some sample
photos and then try downloading them to your computer again. It is also recommended that you have a SD card
inserted in the camera. The minimal requirements are Pentium Processor 300Mhz, AMD Athlon 300Mhz, Celeron
400MHz or higher with at least 128 MB RAM. Please make sure whether the old AMD K6 works normally or not.
More information about your computer is available in the computer property.
Q: How do I make sure that I did not leave out important photos?
To Next Page
Loading...
