70
Chapter 2 Front-Panel Menu Operation
To Configure the Remote Interface
2
4 Establish an “IP Setup.”
If you are not using DHCP (if you have pressed the first softkey to switch
DHCP to Manual), you must establish an IP setup, including an IP
address, and possibly a subnet mask and gateway address. The IP
Address and Subnet Mask buttons are on the main screen, and you
press More to get to the Gateway configuration feature.
Contact your network administrator for the IP address, subnet mask,
and gateway to use. All IP addresses take the dot-notation form
“nnn.nnn.nnn.nnn” where “nnn” in each case is a byte value in the range
0 through 255. You can enter a new IP address using the numeric keypad
(not the knob). Just type in the numbers and the period delimiters using
the keypad. Use the left cursor key as a backspace key. Do not enter
leading zeros. For further information, see “More about IP Addresses and
Dot Notation” at the end of this section.
To Next Page
Loading...
Need help?
General
