2-17
Preparing the Oscilloscope for Use
Selecting a language for Quick Help after you have been operating the oscilloscope
Selecting a language for Quick Help after you have been
operating the oscilloscope
1Press the Utility key, then press the Language softkey to display the
Language menu.
2Press the
Language softkey until the desired language in the list selected.
If the language you want to load is grayed-out in the list, you will need to load
the language from floppy disk. The language file can be downloaded from
www.agilent.com/find/5462xsw
or call an Agilent center and request a language
disk for your instrument
service.book Page 17 Wednesday, December 18, 2002 8:35 AM
To Next Page
Loading...
