3-13
Testing Performance
To verify bandwidth
To verify bandwidth
This test verifies bandwidth. In this test you will use an oscilloscope calibrator
with a level sinewave output.
You will use the peak-to-peak voltage both at 1 MHz and at bandwidth frequency
to verify the bandwidth response of the oscilloscope.
54642A and 54642D
Test limits at 2 mV/div to 5 V/div:
• All channels (±3 dB)
• dc to 500 MHz
• ac coupled 3.5 Hz to 500 MHz
54641A and 54641D
Test limits at 2 mV/div to 5 V/div:
• All channels (±3 dB)
• dc to 350 MHz
• ac coupled 3.5 Hz to 350 MHz
Table 3-6
Equipment Required to Verify Bandwidth
Equipment Critical Specifications Recommended Model/Part
Oscilloscope Calibrator Fluke 5820A
Cable * Type N (m), 24-inch Agilent 11500B
* The oscilloscope calibrator is supplied with 2 or more coaxial cables N (m), BNC (m),
1 meter long, Fluke P/N 686318.
service.book Page 13 Wednesday, August 28, 2002 3:25 PM
To Next Page
Loading...
