Calibration
66
Disabling the Calibration Mode
To disable the calibration mode, press . The display will return to the meter mode with the Cal annunciator off.
If you shut off the power supply with calibration enabled, it will be disabled when you turn it back on.
Calibration Error Messages
The following error messages may appear during calibration:
Table A-3. Calibration Error Messages
CAL ERR0R An entered value is not within acceptable range.
D0ES N0T CAL Computed calibration constant is out of range.
PASSWD ERROR You entered an incorrect password.
WR0NG M0DE The power supply is not in CV or CC mode, as required.
To Next Page
Loading...
Need help?
General
