Installation and Maintenance Using Modules
284 Agilent 8163A/B, 8164A/B, and 8166A/B User’s Guide, Fourth Edition
1 Lift the catch at the bottom front of the module.
2 With the catch lifted, pull the module out of the instrument. If the
module does not slide out freely, check that you have lifted the catch
high enough.
How to Fit a Front-Loadable Module
CAUTION Do not use the electrical or optical connectors to push the module into
the instrument, as this can cause damage to the connectors.
Make sure that the line power is switched off before you fit a module.
Figure 187 How to Remove a Front-Loadable Module
Figure 188 How to Insert a Front-Loadable Module
To Next Page
Loading...
Need help?
General
