EasyManuals Logo

Agilent Technologies 8166B Programming Guide

Agilent Technologies 8166B
274 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #138 background imageLoading...
Page #138 background image
Measurement Operations & Settings Signal Generation – The SOURce Subsystem
138 Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
command:
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:DWELl
syntax: [:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:DWELl<wsp>
<value>|MIN|MAX|DEF[NS|US|MS|S]
description: Sets the dwell time. Can only be used when sweep is stepped.
NOTE Cannot be set while a sweep is running.
parameters: The dwell time as a float value.
If you specify no units in your command, seconds are used as the default.
Also allowed are: MIN: minimum programmable value
MAX: maximum programmable value
DEF: This is not the preset (*RST) default value but is half the sum of, the
minimum programmable value and the maximum programmable value
response: none
example: wav:swe:dwel 500ms
affects: All tunable laser modules
command:
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:DWELl?
syntax: [:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:DWELl?[<wsp>MIN|MAX|DEF]
description: Returns the dwell time. Can only be used when sweep is stepped.
parameters: none
Also allowed are: MIN: minimum programmable value
MAX: maximum programmable value
DEF: This is not the preset (*RST) default value but is half the sum of, the
minimum programmable value and the maximum programmable value
response: The dwell time in seconds.
example: wav:swe:dwel? +5.00000000E-001<END>
affects: All tunable laser modules
command:
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:EXPectedtriggers?
syntax: [:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:EXPectedtriggers?
description: Returns the number of triggers. A tunable laser wavelength sweep causes a number of trig-
gers, this number is required to configure a triggering data acquisition function on a power
meter. The number returned by this function can be used to configure a Power Meter for co-
ordinated measurements with a tunable laser source (see command
“:SENSe[n][:CHANnel[m]]:FUNCtion:PARameter:LOGGing” on page 94).
parameters: none
response: the number of expected triggers as an unsigne integer value.
example: sour0:wav:swe:exp? 12001
affects: All tunable laser modules except Agilent 81649A and Agilent 81689A/B

Table of Contents

Other manuals for Agilent Technologies 8166B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies 8166B and is the answer not in the manual?

Agilent Technologies 8166B Specifications

General IconGeneral
BrandAgilent Technologies
Model8166B
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals