Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition 55
3
Instrument Setup and Status
This chapter gives descriptions of commands that you can use when
setting up your instrument. The commands are split into the following
separate subsytems:
• IEEE specific commands that were introduced in “Common Commands”
on page 29.
• STATus subsystem commands that relate to the status model.
• SYSTem subsystem commands that control the serial interface and
internal data.
IEEE-Common Commands . . . . . . . . . . . . . . . . . . . . . . . . . . 56
Status Reporting – The STATus Subsystem. . . . . . . . . . . . 64
Interface/Instrument Behaviour Settings – The SYSTem
Subsystem. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76
To Next Page
Loading...
Need help?
General
