ILT.3122
Is the front panel SWEEP indicator ashing and do you
have a front panel?
Continue
Go To
A15.9000
ILT.3123
Perform the following setup:
Connect a function generator to the rear panel trigger
input.
Set the function generator for a 10 Hz, TTL square
wave.
Observe the SWEEP OUTPUT on the rear panel.
Go To
ILT.3150 Continue
ILT.3124
Does your instrument have a front panel with a display
and is the front panel SWEEP indicator ashing?
Go To
ILT.3170 Continue
1a-70 Instrument Level Troubleshooting Agilent 8360
To Next Page
Loading...
