6-28
Error Messages
Error Messages in Numerical Order
62 NOT VALID FOR PRESENT TEST SET
63 CALIBRATION REQUIRED
64 CURRENT PARAMETER NOT IN CAL SET
65 CORRECTION AND DOMAIN RESET
66 CORRECTION TURNED OFF
67 DOMAIN RESET
68 ADDITIONAL STANDARDS NEEDED
69 NO CALIBRATION CURRENTLY IN PROGRESS
70 NO SPACE FOR NEW CAL. CLEAR REGISTERS
71 MORE SLIDES NEEDED
72 EXCEEDED 7 STANDARDS PER CLASS
73 SLIDES ABORTED (MEMORY REALLOCATION)
74 CALIBRATION ABORTED
75 FORMAT NOT VALID FOR MEASUREMENT
77 WRONG DISK FORMAT, INITIALIZE DISK
111 DEADLOCK
112 SELF TEST #n FAILED
113 TEST ABORTED
114 NO FAIL FOUND
115 TROUBLE! CHECK SETUP AND START OVER
117 PWR MTR: NOT ON/CONNECTED OR WRONG ADDRS
119 DEVICE: not on, not connect, wrong addrs
123 NO MEMORY AVAILABLE FOR INTERPOLATION
124 SELECTED SEQUENCE IS EMPTY
125 DUPLICATING TO THIS SEQUENCE NOT ALLOWED
126 NO MEMORY AVAILABLE FOR SEQUENCING
127 CAN'T STORE/LOAD SEQUENCE, INSUFFICIENT MEMORY
130 D2/D1 INVALID WITH SINGLE CHANNEL
131 FUNCTION NOT VALID DURING MOD SEQUENCE
132 MEMORY FOR CURRENT SEQUENCE IS FULL
Error
Number
Error
To Next Page
Loading...
Need help?
General
