6-29
Error Messages
Error Messages in Numerical Order
133 THIS LIST FREQ INVALID IN HARM/3 GHZ RNG
141 STOP/CW FREQ + OFFSET MUST BE < 3 GHz
144 NO LIMIT LINES DISPLAYED
145 SWEEP TYPE CHANGED TO LINEAR SWEEP
148 EXTERNAL SOURCE MODE REQUIRES CW TIME
150 LOG SWEEP REQUIRES 2 OCTAVE MINIMUM SPAN
151 SAVE FAILED / INSUFFICIENT MEMORY
152 D2/D1 INVALID: CH1 CH2 NUM PTS DIFFERENT
153 SEQUENCE MAY HAVE CHANGED, CAN'T CONTINUE
154 INSUFFICIENT MEMORY, PWR MTR CAL OFF
157 SEQUENCE ABORTED
159 CH1 (CH2) TARGET VALUE NOT FOUND
161 PRESS [MENU], SELECT CW (IF) FREQ, THEN SWEPT LO
162 EXT SRC: NOT ON/CONNECTED OR WRONG ADDR
163 FUNCTION ONLY VALID DURING MOD SEQUENCE
164 TOO MANY NESTED SEQUENCES. SEQ ABORTED
165 PARALLEL PORT NOT AVAILABLE FOR GPIO
166 PRINT/PLOT IN PROGRESS, ABORT WITH LOCAL
167 PARALLEL PORT NOT AVAILABLE FOR COPY
168 INSUFFICIENT MEMORY FOR PRINT/PLOT
169 GPIB COPY IN PROGRESS, ABORT WITH LOCAL
170 COPY: device not responding; copy aborted
171 PRINTER: paper error
172 PRINTER: not on line
173 PRINTER: not connected
174 PRINTER: power off
175 PRINTER: error
176 PRINTER: busy
177 PRINTER: not handshaking
178 print color not supported with EPSON
Error
Number
Error
To Next Page
Loading...
Need help?
General
