6
• 85038F
7-16 calibration kit (female standards)
Contains fixed load, open, and short circuit with
7-16 female connectors and a 7-16 (f) to 7-16 (f)
adapter. Other adapters not included; see the
“Adapters” section on the next page for informa-
tion about the 11906 series of 7-16 adapter kits.
• 85038M
7-16 calibration kit (male standards)
Contains fixed load, open, and short circuit with
7-16 male connectors and a 7-16 (m) to 7-16 (m)
adapter. Other adapters not included; see the
“Adapters” section on the next page for informa-
tion about the 11906 series of 7-16 adapter kits.
RF electronic calibration modules
This product family provides electronic calibration
(ECal) capability. With ECal, the usual calibration
kit standards are replaced by one solid-state cali-
bration module that can be programmed by the
analyzer’s internal firmware to present many dif-
ferent impedances to the test ports. A full two-port
calibration can be done with a single connection
in a few minutes, with reduced errors and wear
on connectors.
• 85097B
VNA interface kit and software
Contains interface module for connecting an
ECal module to an 8753E, 8753ET and 8753ES
analyzer.
• 85091C
7-mm RF ECal module
• 85092C
50-ohm type-N RF ECal module
• Option M0F
Module with type-N(m) and type-N(f)
connectors.
• Option 00F
Module with two type-N female connectors.
• Option 00M
Module with two type-N male connectors.
• Option 00A
Adds type-N(m) to type-N(m) adapter and
type-N(f) to type-N(f) adapter.
• 85093C
3.5-mm RF ECal module
• Option M0F
Module with 3.5-mm(m) and 3.5-mm(f)
connectors.
• Option 00F
Module with two 3.5-mm female connectors.
• Option 00M
Module with two 3.5-mm male connectors.
• Option 00A
Adds 3.5-mm(f) to 3.5-mm(f) adapter and
3.5-mm(m) to 3.5-mm(m) adapter.
• 85098C
7-16 RF ECal module
• Option M0F
Module with 7-16(m) and 7-16(f) connectors.
• Option 00F
Module with two 7-16 female connectors.
• Option 00M
Module with two 7-16 male connectors.
• Option 00A
Adds 7-16(m) to 7-16(m) adapter and 7-16(f)
to 7-16(f) adapter.