8
75-ohm device measurements
Test-port cables
• 11857B
75-ohm type-N test-port cables
A pair of phase-matched 610 mm (24 in) cables,
for use with the 8753ES Option 075 or the
85046B S-parameter test set.
• Option B24
Deletes phase-match requirement.
• 11851B
50-ohm type-N RF cable kit
For systems based on an 8753ES Option 011.
Includes three phase-matched 610-mm (24 in)
cables and one 860-mm (34 in) cable. Used with
the 11850D power splitter.
• Option B24
Deletes phase-match requirement.
• 11857F
75-ohm type-F cables
Includes one 75-ohm type-N(m) to type-F(m)
cable, Agilent part number 8120-8396, and one
type-N(m) to type-F(f), part number 8120-8397.
Calibration kits
• 85036B
75-ohm type-N calibration kit
Contains 75-ohm fixed loads, open/short
circuits, and 50-ohm type-N to 75-ohm type-N
adapters in both sexes.
• 85039B
75-ohm type-F calibration kit
Includes 75-ohm male/female open, short, and
load standards and precision adapters N(f) to
F(m), N(m) to F(f), F(m) to F(m) and F(f) to F(f).
• Option 00M
male standards kit
Includes male open, short, and load standards
and precision F(m) to F(m) adapter.
• Option 00F
female standards kit
Includes female open, short, and load stan-
dards and precision F(f) to F(f) adapter.
RF electronic calibration modules
This product family provides electronic calibration
(ECal) capability. With ECal, the usual calibration
kit standards are replaced by one solid-state cali-
bration module that can be programmed by the
analyzer’s internal firmware to present many dif-
ferent impedances to the test ports. A full two-port
calibration can be done with a single connection in
a few minutes, with reduced errors and wear on
connectors.
• 85097B
VNA interface kit and software
Contains interface module for connecting an
ECal module to an 8753E, 8753ET and 8753ES
analyzer.
• 85096C
75-ohm type-N RF ECal module
• Option M0F
Module with 75-ohm type-N(m) and type-N(f)
connectors.
• Option 00F
Module with two type-N female connectors.
• Option 00M
Module with two type-N male connectors.
• Option 00A
Adds type-N(m) to type-N(m) adapter and
type-N(f) to type-N(f) adapter.
• 85099C
75-ohm type-F RF ECal module
• Option M0F
Module with type-F(m) and type-F(f)
connectors.
• Option 00F
Module with two type-F female connectors.
• Option 00M
Module with two type-F male connectors.
• Option 00A
Adds type-F(m) to type-F(m) adapter and
type-F(f) to type-F(f) adapter.
To Next Page
Loading...
Need help?
General
