Hardkey and Softkey Reference ESG Family Signal Generators
Utility
4-128 User’s Guide
Power On Last Preset
This softkey toggles the power-on state of the signal generator between
Last and Preset.
• If you choose
Last, each time you cycle power to the signal generator
it will turn on in the same condition as when you turned power off.
The signal generator must not receive commands for a second before
the power is turned off to guarantee that the most recent state is
saved.
• If you choose
Preset, each time you cycle power to the signal
generator it will turn on in either the factory-defined preset
condition or in a user-defined preset condition. You make the choice
between factory- and user-defined preset with the
Preset Normal User
softkey.
The power-on state is a persistent state; it is not affected by an
instrument preset or by a power cycle.
Softkey Location:
Utility > Power On/Preset > Power On Last Preset
Power On/Preset
Pressing this softkey reveals a menu of choices for preset conditions. In
this menu, you have the following options:
• Set the signal generator to power on in the same state as it was
when you powered off, or to power on in the instrument preset state.
(Refer to the
Power On Last Preset softkey description, in this section.)
• Set the signal generator to preset to a factory-defined state or to a
user-defined state. (Refer to the
Preset Normal User softkey description,
in this section.)
• Set up your own user-defined preset state. (Refer to the
Save User Preset softkey description, in this section.)
• Set the signal generator to preset to the SCPI programming
language or to an 8648 or 8656/57-compatible language. (Refer to the
Preset Language softkey description, in this section.)
• Set the signal generator’s reverse power protection to the
factory-defined state or to an 8648-equivalent state. (Refer to the
Reverse Power Protection Normal 8648 softkey description.)
Softkey Location:
Utility > Power On/Preset
To Next Page
Loading...
Need help?
General
