Agilent Technologies E4438C Installation Note

16
Figure 5 W26
Verify Installation of Option 005
1. Turn the instrument on and allow the instrument to warm up for five minutes.
2. Access instrument option information. From the front panel press
Utility > Instrument Info/Help Mode > Options Info.
3. Review the display and verify that 005 HARD DRIVE is listed. If the option is listed, the installation was successful.
CAUTION If an option is enabled that does not have the required hardware installed, the menus for that option will be
activated, but the option will not operate.
A12
W26

Agilent Technologies E4438C Specifications

General

Brand	Agilent Technologies
Model	E4438C
Category	Portable Generator
Language	English