Installation Note E4440-90611 5
Wide Bandwidth Retrofit Kit
Tools Required
❏ T-20 Torx driver
❏ T-10 Torx driver
❏ 5/16-inch torque wrench
❏ 8 mm deep socket or open end wrench
❏ 7/32 inch or 6 mm open end wrench
❏ Calibration software. Latest software information and downloads available at
http://www.agilent.com/find/calibrationsoftware
❏ Test equipment supported by the calibration software.
❏ PSA Series Spectrum Analyzer and Service Guide. This manual is available as the
E4440AU, E4443AU, or E4445AU Option OBW.
❏ Microsoft® Windows® based personnel computer using LAN connection and
CD-ROM drive.
❏ GPIB Interface. Agilent 82350B or 82357B. National Instruments PCI-GPIB or
GPIB-USB-HS
❏ Windows 2000® (Service Pack 4), Windows XP® (Service Pack 2)
❏ Download the latest firmware revision (A.11.xx or later) from
http://www.agilent.com/find/psa_firmware, or order the Firmware Update kit.
The firmware update kit is ordered as E4440AU, Option UE2.
Microsoft®, Windows®, and Windows XP® are US registered trademarks of Microsoft Corporation.
To Next Page
Loading...
Need help?
General
