Chapter 4
Front-Panel Key and SCPI Command Reference
Measurement keys
222
Front-Panel Key and SCPI Command
Reference
4.4.6 PM Deviation Measurement Definition
The PM Deviation measurement consists of 2 views: Numeric Results View and Waveform View.
1. PM Deviation Numeric Results View has two windows:
• PM Deviation Numeric Results Window (upper)
• PM Deviation Settings Window (lower)
2. PM Deviation Demod Waveform View has two windows:
• PM Deviation Waveform Window (upper)
• PM Deviation Numeric Results Window (lower)
Table 4-19 PM Deviation Numeric Results Window
Name Corresponding Results
PM Deviation n=1 1st
PM Deviation output
Modulation Rate n=1 3rd
Modulation Distortion n=1 4th
Modulation SINAD n=1 5th
Table 4-20 PM Deviation Settings Window
Name Corresponding Results
IF BW Type It can be Auto, Manual
IF BW This value is the IF bandwidth set manually
Detector Selection It can be Peak +, Peak -, Peak +/– 2 or RMS
Peak Hold It can be On or Off
HP Filter It can be None, 50 Hz or 300 Hz
LP Filter It can be None, 3 kHz, 15 kHz, 30 kHz or 300 kHz
Table 4-21 PM Deviation Waveform Window
Marker Trace Yes
Corresponding Trace PM Deviation vs. Seconds trace (n=0)
To Next Page
Loading...
Need help?
General
